Publicité
Les langues disponibles
Les langues disponibles
Front and Rear Gear Case
The front and rear gear case must be checked for oil leaks before operating. If any leaks are found, have
your dealer check and repair the vehicle�
Front Gear Case Oil Check
1� Place the vehicle on a level surface.
2� Remove the oil filler bolt (1) and check the oil level. The level should be up to the brim of the hole. If the
level is low, add sufficient oil to raise it to the specified level.
3� Install the oil filler bolt and tighten it to 18.4 ft-lb. (25 Nm).
Front Gear Case Oil Change
1� Place the vehicle on a level surface.
2� Place an oil pan under the gear case to collect the used oil�
3� Remove the oil drain bolt (2) at the bottom of the gear case and
drain the oil�
4� Install the oil drain bolt and tighten it to 18.4 ft-lb. (25 Nm).
5� Remove the oil filler bolt. Add sufficient oil to raise the level up to
the brim of the fill hole (1).
6� Install the oil filler bolt and tighten it to 18.4 ft-lb. (25 Nm).
NOTE:
Approximate front gear case oil capacity: 8.5 oz. (250 mL)
MAINTENANCE
142
1
2
1 Fill bolt
2 Drain plug
Publicité
