Receiving Sms In Case Of Alarm; Failures; Restoring Failure - CAME PXC08 Manuel

RECEIVING SMS IN CASE OF ALARM

In the event of an alarm or particular events (failures, technological alarms, etc .) the security alarm control unit if so programmed will send
an SMS to the pre-set numbers notifying them of the event which triggered the call .
In case of
alarm
Telephone calls
To security services

FAILURES

Failures can be caused by:
• Batteries failed (control unit) .
• Primary power supply failure (230 V AC from control unit) .
• No PSTN or GSM lines .
• Failure-type inputs .
Notification of the failure is not sent immediately, but only after a time period set by the Installer, so as to avoid pointless notifica-
tions in the event of power surges or temporary power outages .
In case of
failures
Telephone calls
To security services
m
Opening the control unit or its components triggers an alarm signal .
m
System maintenance must be performed by qualified personnel .

RESTORING FAILURE

Once the cause that triggered the failure signal has been eliminated, you can reset this signal on the keypad referring to the procedure
described in the section 'Restore Alarm Memory' .
Activation
Sirens
08:24 08:24 19/03/13 19/03/13
#####UUUPX---
#####UUUPX---
Alarm signal on control unit, LCD
and LED keypads
08:24 08:24 19/03/13 19/03/13
#####UUUPX---
#####UUUPX---
Alarm signal on control unit, LCD
and LED keypads
Telephone calls
Voice and SMS
Home of Mr Rossi via Roma 11 Milan
living room window alarm
Alarm signal on
readers
Telephone calls
Voice and SMS
Home of Mr Rossi via Roma 11 Milan
control unit battery failure