Silencing Alarm; Restoring Alarm Memory; Failures; Events - CAME PXC08 Manuel

SILENCING ALARM

To interrupt the alarm use the key or else press the
to access it . To change the code use keys
Depending on the properties assigned to the code, by entering the User Code you can silence the sirens, interrupt telephone calls and, if
necessary, disarm the system .
08:24 08:24 08:24 08:24 19/03/13 19/03/13 19/03/13 19/03/13
#####UUUPX--- #####UUUPX--- #####UUUPX--- #####UUUPX---
m
Entering the User Code will also interrupt telephone calls .
The properties of the User Code are set by the Installer . Get informed about the limits and functions of the code in the event of an
alarm .

RESTORING ALARM MEMORY

After the alarm has been silenced, the keypad will continue to show the alarm event via the red LED
To get rid of this signal (this operation does not cancel the events):
08:24 08:24 08:24 08:24 19/03/13 19/03/13 19/03/13 19/03/13
#####UUUPX--- #####UUUPX---
#####UUUPX--- #####UUUPX---
To interrupt the alarm use the key or else press the
*
to access it . To change the code use keys
08:23 16/05/10 123456
ENTER CODE
WAITING
*=USER MENU
*

EVENTS

02
*
EVENTS MENU
CANC.ALRM. MEM.
* CANC.ALRM. MEM.
*=OK #=ESC
#

FAILURES

Failures can be caused by:
• Battery failure (control unit) .
• Primary power supply failure (230 V AC control unit) .
• Failure-type inputs;
• PSTN down;
• GSM down .
If one of these faults occurs, the keypad will continue to display it until it is resolved and cleared from the memory (see paragraph 'Restoring
Alarm Memory') .
/ESC # key for 5 secs, followed by the User code (default
; to move from character to character press keys
08:24 08:24 08:24 08:24
#####UUUPX--- #####UUUPX--- #####UUUPX--- #####UUUPX---
ENTER CODE
******
ENTER CODE
Press
******
/ESC # key for 5 secs, followed by the User code (default
; to move from character to character press keys
▼ ▲
▼ ▲
*
+ -
19/03/13 19/03/13 19/03/13 19/03/13
Press
system protected
08:24 08:24 08:24 08:24 19/03/13 19/03/13 19/03/13 19/03/13
#####UUUPX--- #####UUUPX---
#####UUUPX--- #####UUUPX---
A
+ -
To restore the alarm memory from the user menu:
1 . Access the User menu by pressing the control unit's
# key for 5 secs, followed by the User code .
*
2 . Press key to confirm
EVENTS
3 . With select
CANC.ALRM. MEM.
4 . With select
5 . Confirm the operation with the
123456
) and press
.
D
Press to
disarm
the system
#
to keep the
flashing .
#
Press to
finish
123456
) and press
.
*
and press .
*
and press .
* #
key . Press to cancel .
*
/ESC