Areas Test; Remote Assistance (Only With Pxtel Board Installed) - CAME PXC08 Manuel
Masquer les pouces
Voir aussi pour PXC08:
- Manuel utilisateur (48 pages) ,
- Manuel d'installation (192 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AREAS TEST
08:23
16/05/10
ENTER CODE
*
WAITING
*=USER MENU
AREAS TEST
10
AREAS TO TEST
*
####
INPUT XXX AL.
*
INPUT DESCRIPT.
#
REMOTE ASSISTANCE (ONLY WITH PXTEL BOARD INSTALLED)
This function enables you to receive remote assistance (phone) about the system from the Installer . Depending on how it has been pro-
grammed by the Installer, remote access can be direct (low security but greater flexibility) or with prior authorisation (high security, but the
User must be present on site) .
If you need assistance contact the Installer .
m
Remote assistance is enabled only when the system is completely off .
m
Launching remote assistance authorises the Installer to access the system configuration remotely .
m
The installer can do the following remotely:
•
Consult the events .
•
Change the configuration .
•
Simulate system management as if he/she were on site .
m
Remote accesses are saved in the events memory .
08:23
16/05/10
ENTER CODE
WAITING
*=USER MENU
REMOTE
11
ASSISTANCE
ASSISTANCE PHONE
*
*=CALL #=ESC
*
#
123456
▼ ▲
▼ ▲
123456
*
▼ ▲
▼ ▲
...ON A
CALL...
To carry out a test of the areas and check the open inputs:
1 .
Access the User menu by pressing the control unit's
key for 5 secs, followed by the User code .
*
2 .
Press key
to confirm
AREAS TEST
3 .
With
select
4 .
To select/deselect the areas to test press keys
5 .
Once the configuration of areas to be tested is chosen, press
to start the test .
6 .
If there are no open inputs,
played; otherwise the list of those that are open can be scrolled
through .
#
7 .
To finish press
.
To receive remote assistance by phone, you must make a call to the
Installer's service centre:
1 .
Phone your Installer to inform him that remote assistance has
been launched .
2 .
Access the User menu by pressing the control unit's
key for 5 secs, followed by the User code .
*
3 .
Press key
to confirm .
REMOTE ASSISTANCE
4 .
With
select
ASSISTANCE PHONE
5 .
With
select
*
6 .
Press
to enable start the call .
m
During the phone call only assistance can interrupt the call . If
the call is not successful, the control unit will automatically interrupt
it .
m
Do not use the phone line during remote assistance .
/ESC #
*
and press
.
+ -
and
.
INPUTS
CLOSED
will be dis-
/ESC #
*
and press
.
.
*
Publicité
Table des Matières
