Sms Commands Table - CAME PXC08 Manuel

SMS COMMANDS TABLE

Function description
CONTROL UNIT STATUS
Query status of control unit,
desc.CRSMS.123456.9000.
active scenario, battery, 230 V
AC network, fuses;
ACTIVATING VIA
SCENARIO
desc.CRSMS.123456.90nn.
Launch scenario
nn=[01..max scenarios]
DEACTIVATING SYSTEM
desc.CRSMS.123456.0000.
Deactivating the control unit
DEACTIVATING
SINGLE AREA
desc.CRSMS.123456.00nn.
Deactivating area 'nn'
nn=[01..max areas]
ACTIVATING SYSTEM
desc.CRSMS.123456.1000.
Activating control unit
ACTIVATING
SINGLE AREA
desc.CRSMS.123456.10nn.
Activating area 'nn'
nn=[01..max areas]
INPUT STATUS
desc.CRSMS.123456.2nnn.
Query input 'nnn'
nnn=[001..max inputs]
EXCLUDING INPUT
Temporary Exclusion/
desc.CRSMS.123456.3nnn.
Rearming of input 'nnn'
nnn=[001..max inputs]
OUTPUT STATUS
desc.CRSMS.123456.4nnn.
Query output 'nnn'
nnn=[001..max outputs]
ACTIVATING OUTPUT
desc.CRSMS.123456.6nnn.
Activating output 'nnn'
nnn=[001..max outputs]
DEACTIVATING OUTPUT
desc.CRSMS.123456.5nnn.
Deactivating output 'nnn'
nnn=[001..max outputs]
EVENTS
desc.CRSMS.123456.8nnn.
Request last nnn events
nnn=[001..050]
Command
Send an SMS to the formatted sender:
Control unit 1#2X3#4U5#6#7#8#9#10#11#12#13#14#15#16#, Going out, Battery
Failed, Network Up, Fuses OK
Or
Control unit 1-2-3-4-5-6-7-8-9-10-11-12-13-14-15-16-, , Battery OK, Network Down,
Fuses Failure
Means:
"1#" area armed
"1-" area disarmed
"1U" area in process of being armed (exit time)
"1X" area in process of being armed with open inputs
(Reply is the same as to the Control unit status query)
(Reply is the same as to the Control unit status query)
(Reply is the same as to the Control unit status query)
(Reply is the same as to the Control unit status query)
(Reply is the same as to the Control unit status query)
'Input Description' Excluded
'Input Description' Stand-by Armed
'Input Description' In alarm Armed
'Input Description' Stand-by excluded until next re-arming
'Input Description' In alarm excluded until next re-arming
(Reply is the same as to the input status query)
Warning: with the same command you can Exclude or Rearm the input
'Output Description' Output nnn active
Or
'Output Description' Output nnn off
'Output Description' Output nnn on
Warning: enable the "Remote control" field associated to the output
'Output Description' Output nnn off
Warning: enable the "Remote control" field associated to the output
Example reply to request for two events:
EVENT N. 001 SWITCH ON 23:15:26 10/02/09 1#2#3#4#5#6#7#8#
EVENT N. 002 CODE N.001 23:15:17 10/02/09 USER 001
Each SMS contains a maximum of 2 events. To answer the request the events will be sent in
several messages, each containing 2 events.
Warning: it is recommended that this command be used with moderation in order to avoid
using up the phone dialler's SMS credit
Reply (with example)