3M DX70 Guide D'utilisation page 9

To reduce the risk associated with environmental contamination:
• Dispose of exhausted batteries in accordance with applicable federal, state
and local regulations.
To reduce the risk associated with explosion, and/or chemicals from a
leaking battery:
• Use only with battery type AAA or equivalent.
• Orient the battery's plus (+) and minus (-) terminals of the batteries
according to the markings found on the remote control.
• Do not leave the battery in the remote for an extended period of time.
• Do not heat, disassemble, short, recharge, or expose to fire or high
temperature
• Do not carry batteries loose in your pocket or purse.
• Avoid eye and skin contact in the event that battery would leak
• Do not mix used and new batteries.
To reduce the risk associated with the hot surface of exhaust louvers:
• Do not touch exhaust louvers during operation.
To reduce the risk associated with the impact of a falling projector:
™
• Use only the 3M
ceiling mount is desired.
• Installation of the 3M wall/ceiling kit must only be performed by qualified
personnel.
• Adhere strictly to the proper installation procedure as outlined in the
installation instruction when installing the 3M wall/ceiling kit.
• Always operator the unit on fat, sturdy, and horizontal surface.
To reduce the risk associated with intense visible light:
• Avoid looking directly into the projector lens while the lamp is on.
To reduce the risk associated with tripping and/or impact:
• Position the power cord and data cable so that they cannot be tripped over.
© 2007 3M 3M
CAUTION
brand wall/ceiling mounting hardware kit if wall or
™
Digital Projector DX70 Product Safety Guide
Safety Information
9