Replacing The Lamp Cartridge - 3M DX70 Guide D'utilisation

Replacing the Lamp Cartridge

To reduce the risk associated with environmental contamination due to
mercury:
• Hg: Lamp in this product contains mercury. Dispose of lamp cartridge in
accordance with applicable federal, state and local regulations.
To reduce the risk associated with exposure to hazardous voltage:
• Disconnect power cord when the projector is not in use, during lamp
replacement, and while cleaning.
• Do not remove any screws other than those specified in the lamp
replacement instructions.
• Do not attempt to service the projector. There are no user serviceable
parts, other than the lamp cartridge, inside the projector. Contact a 3M
authorized service provider for service.
• Do not allow water or other liquids to enter the projector.
To reduce the risk associated with hot surface of lamp cartridge:
• Unplug the projector from the electrical outlet and allow the lamp to cool
for 45 minutes before replacing the lamp .
12 3M
WARNING
™
Digital Projector DX70 Product Safety Guide © 2007 3M