Care And Maintenance; Manufacturer's Warranty - Hilti SCW 70 Mode D'emploi

1. Position the guide rail with the zero mark at the edge of the workpiece and then pivot the rail until the
desired angle shown on the angle scale is opposite the zero mark.
2. Secure the guide rail with the two screw clamps.
6.8.5 Sawing offcuts
1. Secure the guide rail from below with two screw clamps.
The saw must be placed on the guide rail behind the workpiece. Make sure that the saw blade is
not in contact with the workpiece.
2. Position the circular saw on the guide rail a short distance from the starting point of the cut.
3. Switch on the circular saw.
4. Push the saw at a steady speed across the workpiece. The pivoting guard opens as it contacts the
actuating edge of the guide rail and closes again at the end of the rail.
7

Care and maintenance

7.1 Checks after cleaning and maintenance
After cleaning or maintenance, check that all safety devices are fitted and that they function faultlessly.
▶ To check the pivoting guard, open the guard fully by moving the guard operating lever.
◁ The pivoting guard must close quickly and completely when the guard operating lever is released.
7.2 Cleaning the guard
1. Remove the saw blade.
2. Clean the parts of the guard carefully with a dry brush.
3. Use a suitable tool to remove deposits or cuttings from the inside surfaces of the parts of the guard.
4. Fit the saw blade. → page 7
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
9

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
322275
*322275*
English 9