Life Phases - Phoenix Mecano M9 Notice D'assemblage

7.1 Electric cylinder scope of delivery
The electric cylinder will be delivered as an individual component.
The controllers, handsets as well as accessories are not included in the scope of delivery.
7.2 Maintenance
The product is to be checked by suitable personnel for visible and functional damage.
Damage caused by transport and storage must be reported to the responsible person and
Phoenix Mecano Komponenten AG immediately.
Putting damaged electric cylinders into service is forbidden.
The environmental conditions for the storage of the electric cylinder apply as follows:
•
No oil-contaminated air
•
Contact with solvent-based paints must be avoided
•
lowest / highest ambient temperature: -20 deg. Celsius / +60 deg. Celsius
•
relative humidity: from 30 per cent to 75 per cent
•
air pressure: from 700 hPa to 1060 hPa
•
Falling below the dewpoint is not allowed
Divergent environmental factors must be approved by Phoenix Mecano Komponenten AG.
7.3 Important information on installation and putting into operation
It is essential that you note and observe the following instructions.
Otherwise persons could be injured or the electric cylinder or other components could
be damaged.
•
No additional holes may be made in the electric cylinder.
•
This electric cylinder must not be used outdoors.
•
The electric cylinder must be protected against the ingress of moisture.
•
After setting up and putting into operation, it is essential that the plug of the power supply is
freely accessible.
•
The electric cylinder must not be moved to "Block". Risk of mechanical damage!
•
The electric cylinder must not be opened.
•
The user must ensure that there is no danger when the power supply is active.
•
When designing applications with this electric cylinder, take care to avoid crushing and shear
points. These must be respectively secured and marked.
•
If a mains lead and/or feed line is damaged, the electric cylinder is to be taken out of service
immediately.
•
Phoenix Mecano Komponenten AG does not accept any guarantees when the customer uses
their own electric circuitry, exception is with a limit switch.

7. Life phases

57