Phoenix Mecano M9 Notice D'assemblage page 55

6.4.7 End position limiting
The electric cylinder must not be moved to the stop. Limit switches are installed as standard for
limiting the end position.
When commissioning, make sure that the electric cylinder is switched off in the end position
electrically via the limit switch, thus preventing it from moving to the stop.
Versions of the end position limiting
•
Limit switches set in the factory. (LH15; LH15.1; LH15.2; LH15.6; LH15.7; LH15.8).
The stroke can be set subsequently!
•
Lifting lengths that can be set. (LH15.3; LH15.4; LH15.5; LH15.9; LH15.10; LH15.11).
The end position limiting is set to the maximum lifting length when delivered.
Procedure for setting the limit switch
•
Retract the push rod up until the end position electrically and secure in this position against
twisting.
•
Switch off the electric cylinder.
•
Keep turning the push rod clockwise until you reach the desired new position of the end
position.
•
The push rod must no longer be rotated in this condition. Turning the push rod leads to the
adjustment of the desired position of the end position.
•
With the next motorized adjustment the push rod moves to the set position of the end
position.
The different types of assembly 015 have different spindle pitches.
Turning the push rod by 180 degrees results in the following values:
•
0.625 mm path for a nominal speed of 5/10/22 mm/s
•
3.0 mm path for a nominal speed of 25/60/100 mm/s
6.4.8 Installation position
6. Product information
55