Phoenix Mecano M9 Notice D'assemblage page 34

1. Declaration of incorporation
Sources for the applied harmonised standards according to article 7, paragraph 2:
EN ISO 12100:2010-11
The manufacturer or the person authorised are obliged to hand over the special documents for
the partially completed machine to the national authorities on reasoned request. This transfer is
carried out in agreement, in electronic or paper format.
The commercial protective rights remain unaffected by this.
Important note! The partially completed machine must not be put into operation, until, if
required, it has been determined that the machine in which the partially completed machine is to
be installed complies with the regulations of this guideline.
Stein am Rhein / 13/07/2017
Location / Date
Stein am Rhein / 13/07/2017
Location / Date
34
Safety of machinery – General principles for design – Risk assessment and
risk reduction (ISO 12100:2010)
Signature
Signature
Technical Manager
Signatory's position
Managing Director
Signatory's position