Videotec ULISSE2 Manuel D'instructions page 58

PROBLEM During start-up, the Pan & Tilt stays
blocked and the software interface
displays the following message:
CAUSE Ambient temperature is very low.
SOLUTION Wait until the end of the pre-heating
procedure.
PROBLEM The software interface displays the
following message:
CAUSE The ambient temperature is too low.
SOLUTION The movements of the P&T unit
is blocked to prevent mechanical
damage.
56
PROBLEM You cannot focus the image with
the motorised lens:
CAUSE Back Focus adjustment incorrect.
SOLUTION Execute the following procedure by
framing an object at least 20 metres
away.
1-Completely open the iris
2-Bring the zoom to full tele.
3-Focus the subject with Focus far/
Focus near.
4-Bring the zoom to full wide.
5-Focus using the Back Focus
adjustment mechanism on the
camera.
6-Bring the zoom to full tele and focus
the subject with Focus far/Focus near.
7-Bring the zoom to full wide and
check the focus is correct.
MNVCU2_2222_EN