Sunshield Mounting; Assembling The Camera And Motorised Lenses; How To Open The Housing - Videotec ULISSE2 Manuel D'instructions

7 Assembly
7.1 Cameras features
• Only cameras with a 100 baseTx type Ethernet
communication port can be mounted.
• Only cameras powered by a terminal can be
mounted. The Pan & Tilt cannot supply power
directly on the Ethernet cable (Power over
Ethernet).
• The power supply voltage of the camera must be
12Vdc.
• The maximum current absorbed by the camera
must be lower than the value indicated below:
1.5A.

7.2 Sunshield mounting

Fix the sunshield to the housing using the screws and
washers screwed into the upper body of the housing.
Fig. 6
It is recommended to fix the cover as far forward as
possible to protect against sun reflection and water
droplets.
14
7.3 Assembling the camera and
motorised lenses
The customer has to take care of assembling the
camera and lenses.

7.3.1 How to open the housing

Loosen the 2 screws on the side, turn the cover and
the upper half of the body about the opening hinge
axis.
Fig. 7
DANGER!
Mechanical hazard.
Risk of crushing or shearing.
MNVCU2_2222_EN