Web Interface - Videotec ULISSE2 Manuel D'instructions

10.3 Web interface

Browsers supported: Microsoft Internet
Explorer, Google Chrome, Mozilla Firefox.
10.3.1 First access to the web pages
The first operation in configuring the device consists
in connecting to the web interface.
To access the web interface of the product, simply
use a browser to connect to http:/ ip_address.
To operate correctly, the Pan & Tilt must be
configured according to the camera and accessories
installed.
The product, with the self-generated IP
address, cannot transmit video streaming.
Ensure the DHCP server is reachable or, if
necessary, set an IP address not belonging
to the class "Link Local, 169.254.x.x/16" (
10.3.6 Network Page, page 40).
On first access the hardware configuration page
described below will pop up on the screen.
34
10.3.2 Hardware Configuration Page
The Hardware Configuration menu can be used to
configure the unit hardware.
Some fields are displayed dynamically, depending on
the system configuration.
• Camera Type: The camera communication mode
(only for PTZ Master mode).
• Type: Type of communication towards the
camera.
• NONE: The system powers the camera after
the de-icing (the system does not check if the
camera responds to the ping).
• ONVIF CAMERA: The system is configured
to communicate with the ONVIF S profile
camera. The access credentials to Pan &
Tilt will be the same as the user name and
password specified to communicate with the
camera. Enter the user name and password to
communicate with the third party camera. (
6.5.3 Pre-configuration of third party cameras,
page 13). The system powers the camera after
de-icing, checking if this responds to the ping
and the ONVIF protocol.
• CAMHD30X: The system is configured to
communicate with the integrated camera (
11.6 Visible camera module, page 52). The
default credentials to access the device are:
Username: admin, Password: admin.
MNVCU2_2222_EN