How To Install The Camera - Videotec ULISSE2 Manuel D'instructions

7.3.2 How to install the camera

The camera and lenses are to be installed inside the
housing using the appropriate slider (use the screws
and washers provided). The slider is composed of two
parts, the main slider (01) and the camera slider (02).
Fig. 8
Assemble the lens and the camera. If the lens is type
C and the camera is type CS, it is necessary to use a
spacer.
Fig. 9
Tighten the 1/4" camera screw partially so as to
allow the adjustment of the camera slider. The
camera slider can be mounted in different positions.
Depending on the camera slider position, use one of
the two slots to fix the camera. For optimum hold use
the flat and lock washers.
Fig. 10
MNVCU2_2222_EN
02
01
Depending on the shape or size of the lens, it may
be necessary to use a spacer. Align the hole on the
spacer with the hole in the lens.
Fig. 11
Loosen the screws to remove the main slider from the
housing body.
Fig. 12
On the main slider, position the camera, the lens
and the slider of the previously assembled camera.
Partially tighten the 1/4" lens screw, so it can be
adjusted on the main slider. For optimum hold use
the flat and lock washers.
Fig. 13
15