Videotec ULISSE2 Manuel D'instructions page 22

7.4.4.5 One Push Autofocus
Some types of motorised lenses are able to command
the autofocus.
Make the connections as shown in figure.
AF TRIGGER
Fig. 25
7.4.5 Connecting the motorised lenses
controlled via serial line
Certain types of motorised lenses can be controlled
via an RS-485 serial line.
Make the connections as shown in figure.
B A
GND +12V
Fig. 26
20
FOCUS+
FOCUS-
ZOOM+
ZOOM-
AF1
AF2
J7
B
A
J5
AL
COM
DN1
DN2
+12V
GND
J14
7.4.6 Installation of the visible camera
module (optional)
Disassemble the slider in the housing and secure it
to the camera module. Use the screws and washers
provided.
Fig. 27
Place the slider in the case and secure it with screws
previously removed.
There are two connectors on the housing card that
allow you to power and communicate with the
camera (J10, J18, 7.4.1 Housing board description,
page 17). Connect the camera with the 2 cables
supplied.
Fig. 28
Configure the camera type (CAMHD30X, 10.3.2
Hardware Configuration Page, page 34).
MNVCU2_2222_EN