Videotec ULISSE2 Manuel D'instructions page 49

10.3.19 Camera Setting Page
10.3.19.1 Third party camera
The product, with the self-generated IP
address, cannot transmit video streaming.
Ensure the DHCP server is reachable or, if
necessary, set an IP address not belonging
to the class "Link Local, 169.254.x.x/16" (
10.3.6 Network Page, page 40).
Using the Camera Setting menu item, you can access
the web page for the camera installed. Configuration
of the video streaming parameters must be carried
out with ONVIF protocol using a compatible VMS or
the Onvif Device Manager application (recommended
choice). If you need to change the video streaming
directly on the web page of the camera, you need to
re-start the Pan & Tilt at the end of the configuration.
10.3.19.2 Visible camera module
Some fields are displayed dynamically, depending on
the system configuration.
The Camera Setting menu allows you to configure the
integrated channels on the device:
• Zoom: Configuration parameters
• Digital Zoom: It allows enabling or disabling
the digital zoom. (in addition to the optical).
• Zoom Speed: Enables the speed setting when
manually controlled.
• Focus: Configuration parameters
• Autofocus Mode: Enables setting the Autofocus
in continuous mode (CAMERA TRIGGER) or at
the end of movement (PTZ TRIGGER).
• Autofocus Sensitivity: NORMAL: Rapid focus
for frequent movements.
LOW: Improves focus stability especially for
poorly lit or noisy scenes.
• Focus Speed: Enables the speed setting when
manually controlled.
MNVCU2_2222_EN
• Exposure: Configuration parameters
• Exposure Mode: The parameter configures
the exposure algorithm (AUTO, MANUAL, IRIS,
SHUTTER, BRIGHT). The relevant control fields
are displayed based on the mode selected.
• High Sensitivity: With this mode, the maximum
gain increases to give brighter images, even in
dark scenes.
• Backlight Compensation: The parameter
activates the compensation mode for Contre-
jour view.
• Auto Slowshutter: The parameter activates the
scanning mode with a low frame rate.
• Gain Limit: The parameter defines the
maximum gain value for the exposure
algorithm.
• Exposure Compensation: The parameter
enables correction of scene brightness.
• Compensation Value: The parameter defines
the correction of scene brightness value.
47