Videotec ULISSE2 Manuel D'instructions page 51

10.3.20 Masking Page
The configuration page is only available if the
relevant accessory is present (11.6 Visible camera
module, page 52).
The Masking menu allows you to define the areas
that will be masked on the video.
The virtual keyboard allows you to move the unit. Use
the drop-down menu under the virtual keyboard to
set the speed.
The Patrol, Scan Preset and Home buttons are used to
activate the relative functions.
• Selecting the Mask
Fig. 94
• Masking Mode: During PTZ movement, you
can black out certain portions of the video. On
reaching the set position the entire video will be
obscured. Two masking modes are available. The
PAN-TILT mode activates the mask based on both
the coordinates of the horizontal and vertical axes.
The PAN mode activates the mask based solely on
the horizontal axis coordinates.
Fig. 95
MNVCU2_2222_EN
• Mask Start Position: Configures the mask start
position.
Fig. 96
• Mask Stop Position: Configures the mask stop
position.
Fig. 97
• Enables Mask/Disables Mask/Positions in the
Centre of the Mask/Delete all Masks
Fig. 98
Fig. 99
49