System Status - Videotec ULISSE2 Manuel D'instructions

10.3.3 Home Page
The product control interface is displayed if login is
successful.
On the Home page, the operator can view the system
status, view the camera snapshot, move the unit,
check the lenses and accessories, enable the relays
and monitor the status of the alarm inputs.
10.3.3.1 Video Snapshot
This space shows a preview of the video that the unit
is recording. The snapshot resolution and its frame-
rate are fixed and differ from the actual characteristics
of the video stream. To view the video stream quality,
it is necessary to use a VMS or the ONVIF DEVICE
MANAGER.
Fig. 57
MNVCU2_2222_EN

10.3.3.2 System Status

During startup, the system status is displayed in the
snapshot space.
Fig. 58
During normal operation mode, the System Log
menu item is highlighted in yellow and accompanied
by an attention signal if an alarm has been triggered.
Fig. 59
37