Preparatory Work Before Installation; Mounting The Bracket; Cables Management - Videotec ULISSE2 Manuel D'instructions

6.5 Preparatory work before
installation

6.5.1 Mounting the bracket

Different types of supports are available (11
Accessories, page 51). Choose a suitable bracket for
the installation and follow all the instructions in the
suggested chapter.
Take special care when attaching and
fastening down the apparatus. The
clamping system must be able to support
at least 4 times the weight of the entire
equipment, including P&T, lenses and
camera.
The device should be assembled vertically.
Any other position could impair the
performance of the appliance.
Do not attach the device upside down.

6.5.2 Cables management

The connection cables should not be
accessible from the outside. It is necessary
to fasten the cables securely to the support
in order to prevent excessive weight pulling
them out accidentaly.
You must use cables suited to the type of
installation.
Insert the cables into the support so that they
protrude by about 50cm.
For further information refer to the relative chapter (
8.2 Connecting the Pan & Tilt to the system, page 23).
50cm
Fig. 5
MNVCU2_2222_EN
6.5.3 Pre-configuration of third party
cameras
The system can be interfaced to a VMS
(Video Management System) in two
different ways: (8.3.1 Description of the
Master Selection mode, page 25). If you
want to use the PTZ Master mode, you must
configure the camera before installing it in
the housing.
The camera must be pre-configured to acquire an IP
address via DHCP.
The camera must be pre-configured to interface
with the NTP server via DHCP. If the NTP via DHCP
configuration of the camera is not possible, configure
the following static address of the NTP server:
192.0.0.1.
The camera must be pre-configured to communicate
with the Pan & Tilt via the ONVIF S Profile protocol.
Carefully choose your login and password as they will
be used to access the web configuration and pair the
device with the VMS.
The password can only contain the following
characters (a-z, A-Z, 0-9, ,._+@%/-()^*[]{}#;~).
Some cameras may not support the aforementioned
set of characters.
If the camera has an integrated lens, you need to
remove all the camera presets before installing on the
Pan & Tilt.
50cm
13