Videotec ULISSE2 Manuel D'instructions page 27

8.3 Selecting the unit operating
mode
There is a DIP switch inside the base that allows
you to configure the Master Selection mode and
Factory default mode (DIP1, 8.2.1 Connector board
description, page 23).
SELECTING THE UNIT OPERATING MODE (DIP1)
Function SW 1
Master Selection ON
OFF
Factory Default -
-
Tab. 7
To configure the Master Selection function, refer to
the relevant chapter (8.3.1 Description of the Master
Selection mode, page 25).
To configure the Factory Default function, refer to
the relevant chapter (8.3.2 Description of the Factory
Default procedure, page 27).
8.3.1 Description of the Master
Selection mode
The system can be interfaced to a VMS (Video
Management System) in two different ways:
PTZ Master: VMS always interacts with the Pan & Tilt
CPU via the ONVIF protocol. With this configuration
the camera is controlled by the Pan & Tilt CPU via the
ONVIF protocol.
VMS
Ethernet
(ONVIF)
Fig. 39
MNVCU2_2222_EN
SW 2 Description
- PTZ Master
- Camera Master
ON Enabled
OFF Disabled
Camera
Ethernet
(ONVIF)
CPU
Camera Master: VMS always interacts with
the camera via the driver specified. With this
configuration, the camera controls the Pan & Tilt via
the RS-485 serial line.
VMS
Ethernet
Fig. 40
Pan & Tilt can be configured via the web page.
The default credentials to access the device are:
Username: admin, Password: admin. With this
configuration the ONVIF protocol on the Pan & Tilt
Ethernet port is not enabled.
Camera
RS-485
CPU
25