Thermal Cut-Out; Care And Maintenance - Russell Hobbs 19773-56 Mode D'emploi

Masquer les pouces Voir aussi pour 19773-56:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16

THERMAL CUT-OUT

The cut-out operates to protect the element from overheating.
If your fryer stops working:
1.
Switch off, unplug, and let it cool down.
2.
Check the oil level.
3.
If the oil level is below the MIN mark, reset the cut-out.
4.
If the oil level isn't too low, and the cut-out has operated for some other reason, ring Customer
Service.
5.
Use the reset tool to press the reset button and reset the cut-out.
6.
The excess heat will have spoiled the oil, so clean out the bowl and refill with fresh oil.

CARE AND MAINTENANCE

Unplug the appliance and let it cool down before cleaning or storing away.
Normal cleaning
1.
Wipe outer surfaces with a damp cloth.
2.
Put the lid on top of the bowl, to keep dust, etc. out of the oil.
Full cleaning (after every few uses)
Cover the work surface with at least 3 layers of kitchen paper.
You'll need a 5 litre container and a wide necked funnel.
If you want to filter the oil, use a sieve lined with muslin or filter paper.
1.
Remove the lid and basket.
2.
Lift the heating/control unit off.
3.
Pour the oil into the funnel.
4.
Clean the heating/control unit with a clean damp cloth.
5.
Wash the body, lid, basket, and bowl in warm soapy water and dry thoroughly.
` You may wash these parts in a dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface finishes.
The damage should be cosmetic only, and should not affect the operation of the appliance.
If residue builds up on the element, clean it with detergent, and clean more often.
Remove all trace of detergent and dry before reassembling.
Discolouration
With use, the basket, element, thermostats, and control wires will discolour. This is inevitable, harmless,
and won't affect the operation of the appliance.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
8

Publicité

Table des Matières
loading

Table des Matières