Water Supply And Drain Line Sizing/Connections - Manitowoc SD0302A Manuel D'installation, D'utilisation Et D'entretien

Installation Instructions

Water Supply and Drain Line Sizing/Connections

! Caution
Plumbing must conform to state and local codes.
Water
Location
Temperature
Ice Making
35°F (1.6°C) Min.
Water Inlet
90°F (32.2°C) Max.
Ice Making
Water Drain
Condenser
90°F (32.2°C) Max.
Water Inlet
Condenser
Water Drain
Bin Drain
Large Capacity
Bin Drain
ELECTRICAL ENTRANCE
18" (46 CM) VENT TUBE
1/2" DRAIN CONNECTION
PLASTIC FITTING ON OPPOSITE
SIDE DO NOT APPLY HEAT
1/2" (1.3 CM) MIN
OPEN, TRAPPED AND
VENTED DRAIN
10
Water Pressure
20 psi (1.4 bar) Min.
80 psi (5.52 bar) Max.
--- ---
Standard
20 psi (1.4 bar) Min.
150 psi (10.34 bar) Max.
High Pressure Option
20 psi (1.4 bar) Min.
350 psi (24.1 bar) Max.
--- ---
--- ---
--- ---
The exact locations of inlets and drains for the model you are working on may vary.
DRAIN ID
AIR GAP
Typical Water Supply Drain Installation
Ice Machine Fitting
3/8" (.95 cm) Female Pipe Thread
1/2" (1.27 cm) FPT S3300 Only
1/2" (1.27 cm) Female Pipe Thread
1" (2.54 cm) FPT S3300 Only
1" (2.54 cm) FPT Base Drain
S3300 Only
3/8" Female Pipe Thread
1" Female Pipe Thread S3300 Only
1/2" (1.27 cm) Female Pipe Thread
1" (2.54 cm) FPT S3300 Only
3/4" (1.91 cm) Female Pipe Thread
1" (2.54 cm) Male Pipe Thread
3/8" FPT ICE MAKING WATER INLET FITTING,
PLASTIC FITTING ON OPPOSITE SIDE DO NOT
1/2" FPT CONDENSER WATER DRAIN
DO NOT TRAP DRAIN LINE,
LEAVE AIR GAP BETWEEN
DRAIN TUBE AND DRAIN
Section 2
Tubing Size Up to Ice
Machine Fitting
3/8" (.95 cm) min inside diameter
1/2" (1.27 cm) S3300 Only
1/2" (1.27 cm) min inside diameter
1" (2.54 cm) S3300 Only
1/2" (1.27 cm) min inside diameter
1" (2.54 cm) S3300 Only
3/4" (1.91 cm) minimum
inside diameter
1" (2.54 cm) min. inside diameter
APPLY HEAT
3/8" FPT CONDENSER WATER INLET
(WATER COOLED UNITS ONLY)
(WATER COOLED UNITS ONLY)
1/2" CPVC SOCKET AUXILLARY
BASE DRAIN
Part Number 000006520 11/11