Setting Up And Programming The Camera - Sygonix 35469R1 Notice D'emploi

12. Setting up and programming the camera

Make sure that the product is turned off (OFF position) before the using the TEST OFF CAM
PSET switch.
When you first turn on the camera with the switch at the CAM position, the LC display shows the
camera status. The LC display may show the following indicators.
Default settings
Switch position PSET
Battery status
Image recording
Number of
multi- shots
Date and time
This camera allows you to choose between three operating modes - camera mode, preset mode
and standard surveillance mode (see chapter 14, "PRE-TAKE" function).
7 settings levels are available in camera mode:
Level 1: Time and date
Level 2: Image or video
Level 3: Image resolution
Level 4: Multi-shot and video length
Level 5: Motion detection (PIR) / Select time lapse
Level 6: Time-out setting in PIR / Time lapse mode
Level 7: Recording time setting in time lapse mode
The camera automatically switches to power-saving mode if no button is pressed for a
period of 5 minutes. Slide the switch to OFF and then to TEST to activate the camera
again.
46
Image quality
Recording video
PIR mode
User setting
Switch position CAM