Test Led Function; Pset Image Mode; Setting Image Or Video Recording - Sygonix 35469R1 Notice D'emploi

a) Test LED function
Warning
Never point the camera with the test LED at yourself or other persons or animals
when the function is active. Always observe the LED information in the section
"Safety instructions".
• The test LED (4) can be used to test the range of the PIR motion detector and as a countdown
indicator after the camera has been activated.
• Set the TEST OFF CAM PSET switch to CAM to activate the camera.
• After approx. 30 seconds once the camera has been enabled for recording, the LED begins
flashing for approx. 60 seconds. Leave the detection area within 60 seconds. The camera
is now active.
b) PSET image mode
• Set the TEST OFF CAM PSET switch to PSET. This setting
bypasses all user settings and uses the following presets:
PIR mode / image recording / resolution: 5 MP / multi shot
mode: 3 images (3P) / time-out: 30 seconds.
• If you select the preset PSET, the camera operates in PIR
mode only. Time lapse mode (TLS) will not work.
c) Setting image or video recording
• Set the TEST OFF CAM PSET switch to TEST. With this
setting the camera will be programmed.
• The LC display shows the current status. Press the M
button and then press ▼. The LC display flashes the
programming level "2", "CAM" and "VIDEO".
47