Night Vision With Ir Led; Editing And Viewing Files On A Pc - Sygonix 35469R1 Notice D'emploi

15. Night vision with IR LED

At dark, the IR LEDs activate automatically to improve any recordings. The IR LEDs are enabled
in both image and camera mode.
Any recordings will be black and white only. Colour recording is not possible in combination
with the IR LEDs.
Since the IR LEDs are turned on, the current consumption is higher when night vision is active.
Please note that this reduces the battery life. Please review chapter 19. "Technical Data" for
current consumption data.
IR LED overheating protection
The camera features a thermal cut-out device for the IR LEDs. The IR LEDs may overheat at
dark with a short time-out period (under 10 minutes). As soon as the temperature inside the
camera exceeds 60 °C, the camera turns off automatically for approx. 1 hour to cool down. The
camera then turns back on again and continues recording as programmed.

16. Editing and viewing files on a PC

You can view and edit pictures or videos on a PC using the supplied USB cable (25). The
camera is a plug-and-play device and can be used via USB.
The following instructions apply to the camera when it is turned off.
• Before you connect the camera via USB, make sure that the camera is switched off. The
TEST OFF CAM PSET switch must be in the OFF position.
• Connect the USB Mini-B plug of the USB cable to the USB port (15) on the camera. Connect
the USB-A plug to a free USB 2.0/3.0/3.1 port on your PC/notebook.
Camera
USB cable
A-plug
Mini-B plug
PC with USB port
55