Panasonic EYFMH1XC Instructions D'utilisation page 76

2.2 USING THE TOOL MANAGER SOFTWARE
2.2.12 DISPLAYING AND SAVING THE HISTORY LOG
Browse the Graph Data Saved in the Tool Manager software
• When the parameter of [Graph Sending/Storing Timing] is set for [After Every Fastening],
[After Batch Complete], or [NOK Only], the graph data of work progress will also be
recorded in the history log.
• The graph data of work done in [Stand Alone Mode] is recorded in the tool's internal
storage, and can be browsed from the Tool Manager software after the work.
(The graph data of work done in [Wireless Communication Mode] is sent to the applicable
Controller of C.E. Electronics, Inc. by wireless.) For how to browse the graph data sent to
the Controller, read the Operating Instructions of C.E. Electronics, Inc.
Note
• The Tool Manager software calculates a torque waveform from the voltage information of
the torque sensor, independently of the shut-off algorithm of the tool. Therefore, torque
values may be displayed differently from those for shut-off judgment of the tool.
Use them as reference information that shows how the measured torque tends to change.
EN
Time [s]
- 76 -
Continued to the next page