Panasonic EYFMH1XC Instructions D'utilisation page 48

2.2 USING THE TOOL MANAGER SOFTWARE
2.2.8 CONFIGURING PARAMETERS OF THE TOOL
(4) Set Offsets
The torque value shown by the tool and the actual torque on the fastener may differ
depending on the damping caused by the socket and/or the joint condition.
In that case, the torque value shown by the tool can be adjusted by Offset setting.
50.0 Nm
• For the first application, select [Adjust Torque Offset] (①) in Offset on the configured
parameter input screen to calculate offset values automatically.
• If the offset values that were previously set for the tool used for work already exist, you
can set the same torque performance to the tool by entering those values in [Offset_
Slope] and [Offset_Intercept] (②) on the configured parameter input screen.
(For details of [Offset_Slope] and [Offset_Intercept],
• When selecting [Default] (③), you can return the offset values to the model's default
values.
② ●
Note
• To set offsets, you need to empty the history log data in the tool's internal storage.
Following the dialog displayed after [Adjust Torque Offset] is selected, save and delete
the history log data.
(The history log data is saved in the history list.)
EN
45.0 Nm
Offset
① ●
- 48 -
50.0 Nm
.)
Refer to 2.2.9
③ ●
Continued to the next page
50.0 Nm