Panasonic EYFMH1XC Instructions D'utilisation page 56

2.2 USING THE TOOL MANAGER SOFTWARE
2.2.8 CONFIGURING PARAMETERS OF THE TOOL
(6) Register the Set Parameter File to the Tool
• When you select [Write to Tool], the set parameter file will be registered to the tool.
Note
• [Write to Tool] is inactivated and can't be selected when the model number on the parameter file
doesn't mach with the tool model number.
• Before the registration, a dialog lets you check changes from the settings currently
registered in the tool.
• At work in [Stand Alone Mode], the tool runs according to the parameters registered in its
inside.
• The parameter file registered in the tool can be transmitted and registered to the
applicable controller of C.E. Electronics, Inc. by wireless.
(For details on how to register it to the controller, read the Operating Instructions of C.E.
Electronics, Inc.)
EN
- 56 -