Panasonic EYFMH1XC Instructions D'utilisation page 44

2.2 USING THE TOOL MANAGER SOFTWARE
2.2.8 CONFIGURING PARAMETERS OF THE TOOL
This tool can be used by configuring parameters that specify the operation.
(1) How to Use Parameters
The reference source of parameters to be used for work differs between in [Stand Alone
Mode] and in [Wireless Communication Mode].
█ Stand Alone Mode
The tool runs according to the parameters registered in its internal storage.
At configuration
Registering parameters from the Tool Manager software
█ Wireless Communication Mode
The tool runs by receiving for each work the parameters registered in the controller.
The parameters registered in the tool's internal storage are not used.
At configuration
Refer to (6) in this section
CSV file
CSV file
Refer to (7) in this section
To register parameters to the controller, use one of the following methods.
(For details, read the Operating Instructions of C.E. Electronics, Inc.)
① Via tool's internal storage
③ Via C.E. Electronics, Inc. controller setting software
EN
USB cable
Refer to (6) in this section
①
②
Refer to (7) in this section
③
Running according to the parameters sent
from the controller
(The parameters inside the tool are not
used.)
② Via USB memory
- 44 -
At work
Parameters
Running according to the
parameters inside the tool
At work
Parameters Parameters