2.2 USING THE TOOL MANAGER SOFTWARE
2.2.8 CONFIGURING PARAMETERS OF THE TOOL
Various parameters of the tool can be set from the Tool Manager software.
(2) Select a Parameter File to Edit
The parameter file can be selected in one of the following four ways.
█ Selecting the parameter file registered in the tool
From the tool list (①), select a connected tool for which you edit
1
configured parameters.
Select Parameter on the display change tab (②), and click [Read
2
From Connected Tool] (③).
●
①
█ Selecting the parameter file saved in the Tool Manager software
(
Refer to (7) in this section
Select Parameter on the display change tab (①), and click a desired parameter file (②).
EN
●
②
③
●
for how to save the parameter file.)
①
●
②
●
- 45 -
Continued to the next page