Panasonic EYFMH1XC Instructions D'utilisation page 21

2.1 BASIC OPERATION
2.1.1 OPERATION MODE OF THE TOOL
The tool operates in one of the following modes.
The mode in which it is used now is shown on the display of the control panel.
Display
EN
Display
Mode name Mode details
This is a mode in which the tool operates according to the
Stand Alone
configured parameters registered in its inside.
Mode
The history log data is recorded in the tool's internal storage.
The tool does not communicate with the controller.
The Tool Manager software is used to change the setting to
[Stand Alone Mode].
Refer to 2.2.8
This is a mode in which the tool operates via wireless
Wireless
communication.
Communication
The tool communicates with the controller to send history logs
Mode
and receive configured parameters.
The Tool Manager software is used to change the setting to
[Wireless Communication Mode].
Refer to 2.2.8
During work in [Wireless Communication Mode], the tool is in a
Operation
locked state in response to the operation disable signal from the
Disable Mode
controller.
This prevents the tool from being misused by wrong work. The
tool will be unlocked automatically in response to the unlock
signal from the controller.
This is a mode in which to check whether torque control is
Minimum
available when the target torque is low. The tool is shut off at the
Output Mode
minimum number of pulses.
The Tool Manager software is used to change the setting to
[Minimum Output Mode].
Refer to 2.2.8
This is a mode in which to correct the calculated torque of the
Offset Mode
tool for the actual torque.
The Tool Manager software is used to change the setting to
[Offset Mode].
Refer to 2.2.8
This is a mode in which the tool is in the factory default status.
Factory Default
Select [Stand Alone Mode] or [Wireless Communication Mode]
Mode
in accordance with your purpose using the Tool Manager
software before use.
- 21 -