Burkert 8032 Manuel D'instructions page 25

6 maiNteNaNCe
displayed signification
message
ERR 0 Calibration data is lost.
Reading error: the process is
stopped.
ERR 1 Calibration data cannot be saved.
Write error: the process is stop-
ped.
ERR 2 The calibration parameters cannot
be accessed.
Menu reading error:the process
goes on operating.
6.1 Cleaning
The controller 8032 can be cleaned with water or any solution compatible
with the materials the device is made of.
For more information, please contact your Bürkert sales office.
6.2 error messages
What to do
Press the ENTER key to go back to the Normal mode.
The device has returned to its default configuration: the device
must be calibrated again.
If the message appears frequently, send the device back to your
Bürkert sales office.
Press the ENTER key to go back to the Normal mode.
The device displays the configured data; BUT this data has not
been saved: the device must be calibrated again.
If the message appears frequently, send the device back to your
Bürkert sales office.
Press the UP and DOWN keys under the display to scroll through
the menus.
If the message appears frequently, send the device back to your
Bürkert sales office.
Flow rate Controller 8032