Télécharger Imprimer la page

Burkert 8032 Manuel D'instructions page 14

Masquer les pouces Voir aussi pour 8032:

Publicité

Les langues disponibles

Les langues disponibles

1
2
multipin m12 cable plug (not sup-
plied)
- Loosen threaded ring [1]
- Remove part [2] from the connector.
- Wire according to pin assignment (see 4.3.2
or 4.3.3)
8032
4.3 electrical connection
Always ensure the power supply is switched off before working on the
device. All the cable plugs must be plugged out. Use:
- a shielded cable with an operating temperature > +80° C (+176° F).
- a high quality voltage supply (filtered and regulated).
install the following security devices:
- for the power supply: a 1-a fuse
- for the relay: a max. 3-a-fuse and a circuit breaker (depending
on the application).
4.3.1 Cable plugs
type 208 cable plug (supplied)
- Unfasten screw [1].
- Remove part [3] from part [2].
- Unscrew cable gland [5].
- Insert cable into part [2] via cable gland.
- Wire part [3] (see 4.3.2 or 4.3.3)
- Replace part [3] into part [2], by 90°-steps.
- Tighten cable gland [5].
- Place gasket [4] between the cable plug and the fixed connector of
the controller and plug the 2508 onto the fixed connector.
- Tighten screw [1] to ensure tightness and correct electrical contact.
13
2
4
3
1
5

Publicité

loading