Burkert 8032 Manuel D'instructions page 16

4.3.3 Version with relay output
Not connected
Not connected
0 VDC
1
4
3
Common
5
2
1
3
Normally Closed
2
V+ Not connected
(12-30 VDC)
Normally Open
Wiring of the en175301-803
Wiring of the m12 fixed connector
fixed connector, relay output (12-30 Vdc power supply)
The controller is fitted with a steerable M12 fixed connector:
Unfasten counternut. Turn the fixed connector to the right position, but by max. 360° to avoid
twisting of the cables inside the housing. Fasten counternut using the appropriate tool while
maintening the fixed connector in the right position.
operating safety
When the voltage at the relay terminals is higher than 24 V and the cable
plugs are not correctly plugged-in and tightened, there is a risk to elec-
trocute yourself.
Always check all the cable plugs before powering the device to ensure
the good operating of the device.
8032 1