Burkert 8032 Manuel D'instructions page 21

 ProGrammiNG
. Calibration mode
To choose the flow rate unit
(l/s, l/min, l/h, m /min, m /h,
3 3
Ga/s, Ga/min, Ga/h).
To go back to the previous
function.
To go to the next function.
To enter the K-factor (refer to
the fitting S030 manual) or
have it calculated through the
Teach-in feature.
K is the multiplication coeffi-
cient between the rotational
frequency of the paddle-
wheel S030 and the flow rate
to be measured.
** To use the «Teach-In» feature, connect the 8032 controller to a valve which makes it possible to fill a tank with a capacity of
x litres (200 litres for instance).
When the display shows «YES TEAC», press the «ENTER» key and open the valve: The «TEAC» message flashes.
When the tank is full (200 litres), press «ENTER» again. By means of keys
circulated through the circuit (200 litres): the controller calculates the K factor and displays it.
2
ENTER
ENTER
L/S . . .
UNIT
0......9
GA/H
ENTER
0......9
NO
ENTER
TEAC
KFAC
0......9
YES
TEAC
**
* To move the decimal point, press simultaneously keys
ENTER
0......9
ENTER
0......9
if you change the flow rate unit,
change the switching threshold
values, too.
0.534
ENTER
ENTER
KFAC
*
0......9
200.0
ENTER
ENTER
TEAC
VOL
*
0......9
ENTER ENTER
ENTER
0......9 0......9
* *
OHI>
OLO
ENTER
0......9
and
ENTER
Flow rate Controller 8032
0.534
ENTER
ENTER
KFAC
and
0......9
ENTER
ENTER
0......9
ENTER
0......9
, enter the volume of fluid which
ENTER