Burkert 8032 Manuel D'instructions page 17

Flow rate Controller 8032
 ProGrammiNG
.1 General recommendations
Keep in mind that the process may be influenced by all the parameter
settings you make. Fill-in the table on page 22 with your settings of the
controller.
.2 Functionalities
The device has three operating modes:
Normal mode
Display of the measured flow rate and the switching thresholds pro-
grammed. From the Normal mode, you can access the Calibration and
Simulation modes.
Calibration mode
Access to the programming of all the parameters (unit, K-factor, calibra-
tion through the „Teach-in" feature, output, filtre, bargraph and, if available
in your controller version extension board parameters). From the Calibra-
tion Mode, you can go back to the Normal Mode.
simulation mode
Entering a theoretical flow rate value to test the configuration program-
med in the Calibration Mode. Depending on your controller 8032 version,
you may also calibrate the extension board. From the Simulation Mode,
you can go back to the Normal Mode.