Publicité
Les langues disponibles
Les langues disponibles
GB-F-NL-24
Fig. 9
Fig. 10
Fig. 11
Fig. 12
ASSEMBLING THE MOWER
TO THE TRACTOR
Read the Safety Instructions
Ford 333,335 & 3910H
(Fig. 9)
(a)
Fit the front cross member (B) to the tractor
using 2 bolts (F) through the large bosses.
(b)
Fit Right-Hand and Left-Hand front mounting
brackets (A) using four bolts (C) to the tractor.
Connect up cross member (B) with two bolts
(G) and the required packers (H) (See also
page 21 for alignment of frames).
(c)
Fit rear cross angle (D) using four bolts (E) to
right-hand and left-hand mounting brackets (A).
(d)
Fit check chains and brackets to underside of
tractor axle (fig. 4)
(e)
Bolt hose support brackets (A fig. 10)
underneath tractor cab using fixing holes where
the steps were removed and existing bolts
(B fig. 5).
(f)
Remove two bolts underneath the tractor
(C fig. 10) and fix rear hose brackets and clips
(D fig. 10) using screws removed previously.
(g)
Remove plug on top of tractor differential
housing (A fig. 11) and fit the special angled
adaptor plug (B fig. 11) supplied, together with
the quick release coupling (male half).
(h)
Fit tool box (A fig. 12) to mounting plate (B)
using screws (C) and nuts and washers.
GB
Publicité
