SousVideTools 225998 Notice D'utilisation page 6

EN // USER GUIDE
1.6 Now, press the Temperature Icon, the upper display will show the previous SET TEMPERATURE. Lower
display will show °C for 1 ~ 2 seconds. And then show the time.
1.7 Then, press the INCREASE/DECREASE Icon to adjust the SET TEMPERATURE within this 1 ~ 2 Seconds.
The SET TEMPERATURE range is 45°C ~ 90°C. Press once for +0,1˚C / -0,1˚C. Press and hold for +1,0°C /
-1,0˚C.
1.8 When stop to press INCREASE/DECREASE Icon, the SET TEMPERATURE will be stored automatically.
1.9 The Temperature Icon will blink until the SET TEMPERATURE is reached. After reaching the SET
TEMPERATURE, the Temperature Icon lamp will turn off and a short beep sound will be heard and keep
stay of within a range of +0,5˚C / -0,5˚C. If the Actual Temperature over the SET TEMPERATURE about
1°C, the Temperature Display will show "H0t".
NOTE If you don't put water into the water bath and try to switch on the power by step 1.3 to 1.7, the thermal
protection of the appliance will act to stop the power. The upper Temperature Display will show the E2. The
lower Timer Display will show ----. And long beep sound will be heard. The user can only switches OFF the
appliance to stop this warning signal.
2 Operation: SET TIMER
2.1 During cooking, you can activate the TIMER function.
2.2 Press TIME Icon to set the TIMER. The upper display will show "t". Then, press INCREASE/ DECREASE
Icon within 1 ~ 2 seconds to set the TIMER. Press once for + 5,0 min / - 5,0 min. And the lower display will
show the "SET TIMER". And start count down after few seconds.
2.3 The ":" will blink until 00:00 and "END" will be blinked continuously. Two short beep sound will be heard
and the "Timer Icon" will also light off.
NOTE When the TIMER finish counting, the power of the appliance doesn't switch OFF. The water tank will
continue to operate and keep the temperature stable.
2.4 You can also press Timer Icon to start count down from 00:00 in ascending order by pressing the Timer
Icon once for 2 ~ 3 seconds. Press again to cancel this function.
NOTE Time in count down can be adjusted all time
• During Timer is counting, if the user presses the Timer icon, Timer counting will be suspended and shows
the time left
• In this moment, the user can adjust the Timer value
If during operation, water in the water bath has been dry up, the thermal protection of the appliance will act to
stop the power. The upper Temperature Display will show the E2. The lower Timer Display will show ----. And
long beep sound will be heard. The user can only switches OFF the appliance to stop this warning signal.
3 Switch it OFF
3.1 Switch it off by press the ON/OFF switch Icon one time.
Closing the lid
After you set the time and temperature and put vacuumed food in the water tank, you need to close the lid. To
position the lid correctly on the tray, open the vent valve first. Only then you can position the lid correctly. As
soon as the lid closes well, close the vent valve. Put the vacuumed pouch into the water when the water has
reached the target temperature for cooking. If you use more bags, put them in the rack and be sure that all
pouches are completely submerged.
6