Publicité
Les langues disponibles
Les langues disponibles
EN //
USER GUIDE
PREPARATIONS BEFORE USING FOR THE FIRST TIME
•
Check to make sure the appliance is undamaged. In case of any damage, contact your supplier immediately
and do NOT use the appliance.
•
Remove all the packing material and protection film (if applicable).
•
Clean the appliance with luke-warm water and a soft cloth.
•
Place the appliance on a level and steady surface, unless mentioned otherwise.
•
Make sure there is enough clearance around the appliance for ventilation purposes.
•
Position the appliance in such a way that the plug is accessible at all times.
Important: For item 225998 (GN 1/1), please install & fix the drain tap to the appliance before use.
U S E
1
Operation: SET TEMPERATURE
1.1 Fill the container with (hot) water and make sure that the water will not come over the edge on the inner
mark (groove) of the water tank. Remember that placing food in the water will also raise the water level
– it should still not pass aforementioned groove. Water should be filled up to the Max Mark no matter the
amount of food you are going to put into the water bath for cooking
1.2 Connect the power plug to a suitable electrical power outlet
1.3 Press the ON/OFF Icon.
1.4 Then blue LED in the ON/OFF Icon is ON. The upper Temperature display will show the last SET
TEMPERATURE. The lower display will show the appliance is in standby mode (----).
NOTE
The appliance beeps once for a short time
1.5 Press INCREASE/DECREASE Icon, the lower display will show, the heating element is switched ON. At
this moment, The Temperature Display will show the ACTUAL TEMPERATURE. The lower Timer Display
will show the last set time.
5
Publicité
