Authorized Use; Basic Safety Instructions - Burkert 2006 Mode D'emploi

2

AUTHORIZED USE

Non-authorized use of the globe valve type 2006 may be a
hazard to people, nearby equipment and the environment.
▶ The device is designed for the controlled flow of liquid and
gaseous media.
▶ In areas at risk of explosion, only use devices approved for
use in those areas. These devices are labeled with a separate
Ex type label. When utilized in a potentially explosive atmo-
sphere, always pay attention to the details on the separate Ex
type label and the Ex additional instructions contained in the
scope of delivery.
▶ Devices without a separate Ex type label may not be used in
a potentially explosive area.
▶ During use observe the authorized data, the operating condi-
tions and conditions of use specified in the contract docu-
ments and operating instructions.
▶ Protect device from damaging environmental influences
(e.g. radiation, humidity, steam, etc.). If anything is unclear,
consult the relevant sales office.
▶ The device may be used only in conjunction with third-party
devices and components recommended and authorized by
Bürkert.
▶ Correct transportation, correct storage and installation and
careful use and maintenance are essential for reliable and
faultless operation.
▶ Use the device only as intended.
2.1 Definition of the term "Device"
In these instructions, the term "device" always refers to the globe
valve type 2006.
4
english
Type 2006
Authorized Use
3

BASIC SAFETY INSTRUCTIONS

These safety instructions do not make allowance for any
• contingencies and events which may arise during the installation,
operation and maintenance of the devices.
• local safety regulations; the operator is responsible for observing
these regulations, also with reference to the installation personnel
(e.g. by means of a warning label on the device regarding the
use of hot media).
Risk of injury from high pressure and discharge of medium.
▶ Before working on the device or system, switch off the pres-
sure. Vent or drain lines.
Risk of injury from electric shock (when electrical component
installed).
▶ Before reaching into the device or the equipment, switch off
the power supply and secure to prevent reactivation!
▶ Observe applicable accident prevention and safety regula-
tions for electrical equipment!
Risk of injury from moving parts in the device!
▶ Do not reach into openings.
Risk of burns and risk of fire due to hot device surface if duty
cycle is long or medium temperature is high
▶ Keep the device away from highly flammable substances and
media and do not touch with bare hands.