Assembly - Burkert 2006 Mode D'emploi

6

ASSEMBLY

DANGER
Risk of injury from high pressure in the equipment.
▶ Before dismounting pneumatic lines or valves, turn off the
pressure and vent the lines.
WARNING
Risk of injury from improper assembly.
▶ Installation may be carried out by authorized technicians
only and with the appropriate tools.
Risk of injury from unintentional activation of the system and
an uncontrolled restart.
▶ Secure system from unintentional activation.
▶ Following assembly, ensure a controlled restart.
For control function I: Danger if control pressure fails.
For control function I control and resetting occur pneumati-
cally. If the pressure fails, no defined position is reached.
▶ To ensure a controlled restart, first pressurize the device with
control pressure, then switch on the medium.
Type 2006
Assembly
CAUTION!
Risk of injury due heavy devices!
▶ During transport or during assembly, a heavy device may fall
and cause injury.
▶ Do not transport, install or remove heavy devices without the
aid of a second person and using suitable auxiliary equipment.
▶ Use appropriate tools.
6.1 Before installation
→ Before connecting the valve, ensure the pipelines are flush.
→ Observe direction of flow (see type label).
→ Clean pipelines (sealing material, swarf, etc).
Any installation position is possible, preferably with actuator face
up.
Devices with approval in accordance with DIN EN 161
In accordance with DIN EN 161 "Automatic shut-off valves for
gas burners and gas installations" a dirt trap must be connected
upstream of the valve and prevent the insertion of a 1 mm plug
gauge.
6.2 Installing the body
→ Connect body to pipeline.
6.3 Rotating the drive
The position of the connections can be aligned steplessly by
rotating the drive through 360°.
english
9