Burkert 2006 Mode D'emploi page 10

NOTICE
Damage to the seal on the swivel plate.
▶ When turning the actuator, ensure that the valve is in the
open position.
→ Clamp the valve body into a holding device (applies only to
valves not yet installed).
→ For control function A pressurize the lower control air connection
with compressed air (4 bar): Valve opens.
→ Using a suitable open-end wrench, counter the wrench flat on
the pipe.
→ Place a suitable open-end wrench on the hexagon of the actuator
(see "Fig. 2").
WARNING
Risk of injury from discharge of medium and pressure.
If the direction of rotation is wrong, the body interface may
become detached.
▶ Turn the actuator in the specified sense of direction only
(see "Fig. 2").
→ By turning the open-end wrench clockwise (viewed from above),
move the actuator into the required position.
10
english
Type 2006
Assembly
Open-end wrench
for turning the
actuator
Fig. 2: Turning with open-end wrench
Open-end wrench for
securing the nipple