Wall-Mounted Installation-Recirculating; Ductwork, Wiring Locations - Monogram ZV800 Instructions D'installation

WALL-MOUNTED INSTALLATION—RECIRCULATING

DUCTWORK, WIRING LOCATIONS

■ D etermine the exact location of the vent hood.
■ L ocate the template packed with the literature.
■ M easure 36" from the floor to the top of the cooking
surface. Add hood installation height determined on
page 7. Mark that location.
Drill 1/8"
Pilot Holes
13-3/4"
12-3/4"
REAR WALL TEMPLATE
Drill 1/8"
Pilot Holes
2-1/16"
49-80271 JR 07-04
■ T ape the template in position along the penciled line.
CHECK TO BE SURE THE TEMPLATE IS LEVEL.
■ U se a level to draw a line straight up, from the
centerline on the template to the ceiling.
HOUSE WIRING LOCATION:
■ T he junction box is located on the top left side of
the hood.
■ W iring should enter the back wall 20" to 26" above
the bottom of the hood, and within 4" of the right
side of the centerline.
14
Installation Instructions
Ceiling
Drill 1/8" Drill 1/8"
Pilot Holes Pilot Holes
Drill 1/8"
Pilot Holes
5-1/16"
9-5/8"
C L
Drill 1/8"
Pilot Holes
ALIGN BOTTOM EDGE WITH
PENCIL LINE INDICATING
8-1/8"
BOTTOM OF THE HOOD.
1
INSTALL FRAMING FOR HOOD
SUPPORT
IMPORTANT: Framing must be capable of supporting
100 lbs.
8" Min. Opening for Ductwork
Centerline of
Centerline of
installation
Installation
space
Space
If drywall is present, mark the screw hole locations for
the top mounting brackets. Remove the template.
■ C ut away enough drywall to expose 2 vertical studs
at the bracket location indicated on the template.
■ I nstall a horizontal support at least 1" x 6" between
two wall studs at the mounting screw location. The
horizontal support must be flush with the room side
of the studs. Use cleats behind both sides of the
support to secure to wall studs.
IMPORTANT: Reinstall drywall for an even mounting
surface.
View From Rear
View from rear
Cleats
cleats
1" x 6" Min. 1" x 6" min.
mounting
Mounting
support
Support
1" = 2.5 cm; 1' = 0.3 m
49-80267 Rev. 4