Installation-Recirculating; Ductwork, Wiring Locations; Step 1, Install Framing For Hood Support - Monogram ZV830 Mode D'emploi

DUCTWORK, WIRING LOCATIONS

• Determine the exact location of the vent hood.
• Locate the template packed with the literature.
"
• Measure 36 from the floor to the top of the cooking
surface. Add hood installation height determined on
page 7. Mark that location.
5-1/2"
House Wiring
Location
1-1/4"
10-1/16"
TOP
MOUNTING
NOTE: Top
HOLE
mounting
screws MUST
DRILL 1/8"
engage wood
PILOT HOLE
support.
18"
9-7/16" 15-7/16"
Min.
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
• Tape the template in position along the penciled line.
CHECK TO BE SURE THE TEMPLATE IS LEVEL.
• Use a level to draw a line straight up, from
the centerline on the template to the ceiling.
HOUSE WIRING LOCATION:
• The junction box is located on the top left side
of the hood.
• Wiring should enter the back wall at least 18
above the bottom of the hood, and within 5-1/2
of the centerline.
Installation Instructions
INSTALLATION—RECIRCULATING
Ceiling
C
L
1-1/4"
TOP
MOUNTING
NOTE: Top
HOLE
mounting
screws MUST
DRILL 1/8"
engage wood
PILOT HOLE
support.
REAR WALL
MOUNTING TEMPLATE
15-7/16" 9-7/16"
C L
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
"
"
1 INSTALL FRAMING
FOR HOOD SUPPORT
IMPORTANT:
of supporting 100 lbs.
8" Min. Opening for Ductwork
Centerline of
Centerline of
installation
Installation
Space
If drywall is present, mark the screw hole locations for
the top mounting brackets. Remove the template.
• Cut away enough drywall to expose 2 vertical studs
at the bracket location indicated on the template.
• Install a horizontal support at least 1
between two wall studs at the mounting screw
location. The horizontal support must be flush with
the room side of the studs. Use cleats behind both
sides of the support to secure to wall studs.
IMPORTANT: Reinstall drywall for an even mounting
surface.
14
Framing must be capable
View from rear
View From Rear
cleats
Cleats
1" x 6" min.
1" x 6" Min.
mounting
Mounting
support
Support
space
" "
x 6