WALL-MOUNTED INSTALLATION—VENTED TO THE OUTSIDE
4
PREPARE THE HOOD
■ R emove the hood from the box. Remove packaging
and tape.
Electrical
panel
■ R emove one screw on each side of the cover on
the electrical panel. Lift off the cover and set aside
with screws.
■ S tand the electrical panel upright.
■ A lign the screw holes in the bottom of the panel
with the holes on the base of
the hood at the front side.
■ I nstall 3 screws provided.
1" = 2.5 cm; 1' = 0.3 m
49-80267 Rev. 4
Installation Instructions
Remove 2 side
cover screws
Junction box
Inside screw
Secure electrical
panel with 3
screws
5
MOUNT THE HOOD
Install a wood
screw on each
side of the
mounting frame
■ L ift the hood onto the mounting bracket.
■ C heck to be sure it is level.
■ I nstall wood screws through the hood and into the
wall on each side of the mounting bracket.
■ E xtend the canopy forward for better access to the
rear mounting screw holes.
■ I nstall 2 wood screws or fasteners through the
bottom of the hood into the wall.
Mounting
bracket
Install bottom
mounting screws
11