Monogram ZV800 Instructions D'installation page 13

WALL-MOUNTED INSTALLATION—VENTED TO THE OUTSIDE
8
INSTALL DUCT COVERS
■ P lace the decorative duct
covers on top of the hood.
NOTE: The inside (upper)
duct piece has holes on one
end. The holes are intended
for use when the hood is
installed for recirculating
purposes. Slide the vented
end into the outer piece, the
vent holes should not be
visible in this installation.
The inside duct piece must slip into the folded ends of
the outer section.
Install
2 bottom
duct cover
screws
■ E xtend the inner duct upwards to the ceiling
bracket.
■ S ecure duct cover to ceiling bracket with 2 screws.
■ S ecure the lower duct cover to the hood by
installing 2 screws from the bottom of the hood into
the duct cover.
1" = 2.5 cm; 1' = 0.3 m
49-80267 Rev. 4
Installation Instructions
Mounting
screws
Install 2 screws,
duct cover and into
ceiling bracket
9
INSTALL FILTERS
■ R emove protective film on the filters.
Filter Locks
NOTE: The charcoal filter is not required for this installation.
■ T ip the filter into the slots at the rear of the opening.
Lift the filter lock and pull forward until the filter rests
in the slots.
■ I nstall both metal grease filters.
■ T o remove the filters, press inwards on the handle
and pull the filter downwards.
10
FINALIZE INSTALLATION
■ R emove all packaging materials.
■ R efer to the Owner's Manual for operating
instructions.
13