Weekly Maintenance - STAMOS WIG Schweißgeräte Manuel D'utilisation

manual welding with the electrode
• Connect the E-Hand conduit to the negative pole (-).
• Set the current intensity regulator at the proper intensity
(the impulse current intensity regulator is in lower position). Select current
in accordance with empirical formula: I=40d,
where d is the electrode diameter.
• Positive and negative connection during the welding process.
• The welder has to be connected to the electric supply socket and turn main
switch on. the control lamp will light.
• It is necessary to bring the attention to the relative intensity of welding cur
rent and the relative welder's make-time.
• The overloading may result in damages. You can avoid this.
• After finishing the device operation, it is necessary to leave the device for
cooling and then – switch off the supply.
maIntenanCe
The gun has to be checked for wear, cracks or bare conduits. All worn elements have
to be repaired or replaced before next operation of the device. Strongly worn gun
nozzle may result in the decrease of welding speed, voltage drop and uneven material
cutting line. The gun nozzle strongly worn symptom is the extended or too big hole.
External part of the electrode should not be located deeper than 3.2 mm. Check the
screw thread if there is problem with tightening protective cap.

Weekly maintenance

Check if the room ventilation works properly.
en
66