STAMOS WIG Schweißgeräte Manuel D'utilisation page 44

fumes and gases from your breathing zone and general area.
• Where ventilation is questionable, have a qualified technician take an air
sampling to determine the need for corrective measures.
Use mechanical ventilation to improve air quality. If engineering controls are
not feasible, use an approved respirator.
• Work in a confined area only if it is well ventilated, or while wearing an air-
supplied respirator.
• Follow OSHA guidelines for Permissible Exposure Limits (PEL's) for various
fumes and gases.
• Follow the American Conference of Governmental Industrial Hygienists re
commendations for Threshold Limit Values (TLV's) for fumes and gases.
• Have a recognized specialist in Industrial Hygiene or Environmental Services
check the operation and air quality and make recommendations for the speci
fic welding or cutting situation.
10. Always keep hoses away from welding/cutting spot. Examine all hoses and
cables for cuts, burns, or worn areas before each use. If any damaged areas are found,
replace the hoses or cables immediately.
11. read and understand all instructions and safety precautions as outlined
in the manufacturer's manual for the material you will weld or cut.
12. Proper cylinder care. Secure cylinders to a cart, wall, or post, to prevent them
from falling. All cylinders should be used and stored in an upright position. Never drop
or strike a cylinder. Do not use cylinders that have been dented. Cylinder caps should
be used when moving or storing cylinders. Empty cylinders should be kept in specified
areas and clearly marked "empty."
13. never use oil or grease on any inlet connector, outlet connector, or cy-
linder valves.
14. Use only supplied torch on this Inverter air Plasma Cutter. Using compo-
nents from other systems may cause personal injury and damage components within.
15. People with pacemakers should consult their physician(s) before using
this product. Electromagnetic fields in close proximity to a heart pacemaker could
cause interference to, or failure of the pacemaker.
en
44