STAMOS WIG Schweißgeräte Manuel D'utilisation page 50

6.
UP SloPe = automatic, stepless increase of the electric current inten-
sity at the initialization of the electric arc in order to avoid fusions. This
function is adjusted within "second" intervals.
7.
CURRENT = main current adjustment from 10 to 250 A.
8.
BASE CURRENT = low current. This function acta only at switched
on pulsation It is used for switching the current between main current
(CURRENT) and low current during pulsation welding.
9.
doWn SloPe = automatic, stepless decrease of the electric current
intensity at the decay of the electric arc in order to avoid fusions. This
function is adjusted within "second" intervals.
10.
AC FQ = this function is significant only for aluminium welding. It
AC
makes it possible do adjust the frequency which is important factor in
case of welding aluminium metal plates of a various thicknesses and in
particular: for welding thin aluminium metal plates.
11.
START CURRENT = initial current. It acts only with switched on 4T
function. This function is used for adjusting the initial current in order
to properly initiate electric arc. UP SLOP function will increase the
current up to the working value and it will protect material against
fusion.
en
50